How to Start a Tiller With a Choke
To start a gas tiller with a choke, set the fuel valve on, move the choke to the closed (full choke) position for a cold engine, set the throttle as your manual directs, and pull the starter rope until the engine fires. Then open the choke gradually as the engine warms up. A warm engine usually needs little or no choke.
Check these things before you pull the cord
A few minutes of prep saves a lot of pulling. Most hard starts come from old fuel, low oil or a blocked air filter, not from the choke itself.
Always set the tiller on firm, level ground in an open area, with the tines clear of rocks, hoses and your feet. Your owner's manual is the final word on control names and positions, because layouts differ between brands.
- Check the oil level and top it up if needed. Many four-stroke engines will not run, or will shut off, when oil is low.
- Check that the fuel is fresh. Gas that has sat over winter is a common reason an engine will not fire.
- Look at the air filter. A clogged filter starves the engine of air.
- Make sure the spark plug wire is firmly attached.
- Disengage the wheel drive and tine clutch, if your model has them, so the machine does not lurch forward.
How to start a cold engine with the choke
A cold engine needs a richer mix of fuel and air. The choke restricts incoming air to give it that mix. Here is the usual order of steps.
Models differ, so match these steps to your manual.
- Turn the fuel valve to the on position, if there is one.
- Set the engine switch to on or run.
- Move the choke lever to the closed or full choke position.
- Set the throttle to the start or fast position, as the manual directs. If your engine has a primer bulb, press it the number of times listed in the manual.
- Hold the handlebar firmly and keep the tines disengaged.
- Pull the starter rope with a smooth, firm stroke. Let it rewind under control instead of letting it snap back.
- When the engine fires, move the choke halfway open right away. Let it run for a short time, then open the choke fully as the engine smooths out.
Restarting a warm engine
If the engine has just been running, it is already warm and holds some fuel in the cylinder. Using full choke now can flood it, which makes it harder to start, not easier.
Try starting with the choke open, or only partly closed. If the engine coughs and dies, add a little choke and try again. If you smell raw fuel and the plug is wet, you may have flooded it. Wait a few minutes, open the choke, set the throttle to fast and pull several times to clear the extra fuel.
Choke settings at a glance
The right setting depends on engine temperature. This table gives the general pattern for small gas engines.
| Situation | Choke position | What to watch for |
|---|---|---|
| Cold engine, first start of the day | Closed (full choke) | Engine should fire in a few pulls |
| Engine just fired, still cold | Halfway, then opening | Open it slowly as the engine smooths out |
| Engine warm after a short stop | Open or slightly closed | Too much choke can flood the engine |
| Hot day | Less choke than usual | Engine may start with little or none |
| Engine runs rough with choke on | Open the choke | Black smoke or sputtering means too rich |
If it still will not start
If you have pulled the cord many times with no result, stop and check the basics rather than pulling harder. Repeated hard pulls can strain the rope and your shoulder.
Work through these checks in order. If none helps, a small engine shop can clean the carburetor, which is a common fix for engines that have sat with old fuel.
- Confirm the fuel valve and engine switch are both on.
- Check that the choke plate actually closes when you move the lever. A stuck choke gives the wrong mix.
- Replace old fuel with fresh fuel.
- Inspect the spark plug. If it is wet, dry it. If it is fouled or worn, replace it.
- Clean or replace the air filter.
- Check the oil level again, since low oil can block starting on many models.
Does your tiller have a choke at all?
Only gas engines use a choke. Corded and cordless electric tillers start with a switch or trigger, so there is nothing to prime or choke. If you are deciding between power types, our best tiller comparison lays out the trade-offs side by side.
Gas power suits hard ground. For example, the Earthquake Victory rear tine model on our list has a 209cc four-cycle engine, tills 16 in wide and 10 in deep, and has a reverse gear. It also weighs 154 lb, so it takes more effort to move than the electric options.
The electric models are a different story. The corded tillers on our list weigh 24.36 lb to 27.08 lb, and the two cordless models list 40 to 50 minutes of runtime. If starting a gas engine sounds like more work than you want, our tiller comparison shows which electric models cover which bed sizes.
Safety notes
A tiller's tines can cause serious injuries, and a gas engine adds fuel and exhaust hazards. Take these steps every time.
Never run a gas engine in a garage, shed or other enclosed space, because exhaust contains carbon monoxide. Let the engine cool before refueling, and never add fuel to a hot or running engine. Wipe up spills and keep sparks and flames away.
Wear safety glasses, hearing protection, sturdy closed shoes and long pants. Keep children and pets well away. Shut off the engine and wait for the tines to stop completely before clearing jammed roots or rocks, and disconnect the spark plug wire before any hands-on work near the tines.
Frequently asked questions
Should I use the choke when the engine is already warm?
Usually not. A warm engine already has the heat it needs, and extra choke can flood it. Start with the choke open and add a little only if it stalls.
Why does my tiller start and then die after I open the choke?
You may have opened it too fast, or the carburetor may be dirty from old fuel. Open the choke in small steps. If the problem continues, fresh fuel or a carburetor cleaning often helps.
Why does my engine smoke or run rough with the choke on?
The mix is too rich. Move the choke toward open as soon as the engine is running, and avoid full choke on warm days.
Do I need to prime the engine as well as use the choke?
Only if your model has a primer bulb. Some engines use both and others use just the choke, so follow your manual.
How long should I let the tiller warm up before I start tilling?
Let it run a short time until it idles smoothly with the choke fully open. Your manual may give a more exact guide for your engine.
LawnMaster TE1318MBest overall
BILT HARD TOA-0456Wide front-tine option
EARTHQUAKE 39381Deepest, for hard ground