How to Safely Use a Ladder on a Roof
Use an extension-style ladder that rises about 3 feet above the roof edge. Set it on firm, level ground at roughly a 4-to-1 angle (1 foot out for every 4 feet of height), and tie it off at the top. Keep three points of contact while climbing, never carry a load in your hands, and stay off the ladder in wet, icy or windy conditions.
Start with the right ladder for roof access
A step ladder is the wrong tool for reaching a roof. It is built to stand on its own, and it cannot lean on the eave and extend past it. For roof access you want a straight or extension-style ladder, which includes telescoping models and multi-position ladders set up in their straight configuration.
Length matters more than most people expect. The ladder should reach about 3 feet above the roof edge, so you have something solid to hold as you step on and off. A ladder that only touches the edge forces you to let go of it at the worst moment.
Also remember that a listed max reach is not the same as the ladder's length. Max reach describes how high a person can work from it, so check the maker's notes and measure your eave height before you decide. Our best ladder page lists reach, load capacity and standards side by side to help with that check.
Check the ladder and the load before you climb
Spend a minute on inspection every time. A ladder that looks fine can still have a bent rung or a worn foot pad.
Then add up your load. Capacity has to cover your body weight plus your tools and any materials you carry. Among the products on our comparison page, listed capacities run from 300 lb to 800 lb, and a duty rating such as Type IA (300 lb) is a clearer label than a capacity number alone.
- Look for bent, cracked or loose rungs, rails and hinges.
- Confirm every locking latch or pin engages fully and holds.
- Check that the feet are clean and the anti-slip pads are intact.
- Wipe mud, oil or wet leaves off the rungs and your boot soles.
- Read the labels for the duty rating and standards, and do not use a ladder with missing labels if you cannot confirm its rating.
- Skip any ladder that has been bent, dropped hard or repaired by a homemade fix.
Set up the base, angle and top
Most ladder falls start with a bad setup, so slow down here. Put the feet on firm, level ground. If the ground slopes or is soft, level the ladder with a proper leveling device or choose another spot. Do not stack bricks or boards under a foot.
For the angle, use the 4-to-1 rule. For every 4 feet of height to the contact point, set the feet 1 foot away from the wall. Too steep and the ladder can tip backward. Too shallow and the base can slide out. A quick check is to stand with your toes at the feet and reach straight out: your palms should land on a rung.
Secure the ladder at the top by tying it to a solid anchor or using a stabilizer. Have someone foot the base if you cannot tie off. Set it away from doors, driveways and walkways, or block them off.
Look up before you place the ladder. Power lines, service drops and tree branches near the roof edge are real hazards. Keep well clear of electrical lines, and never use a metal ladder anywhere near them. If lines run close to the work area, call a professional or your utility.
Climb and step onto the roof
Face the ladder and keep three points of contact at all times, which means two hands and one foot, or two feet and one hand. Wear shoes with clean, dry, non-slip soles.
Do not carry tools or materials in your hands. Use a tool belt for small items, and raise heavier things with a rope or have a helper hand them up once you are in a safe position.
At the top, step across to the roof while your hands are still on the rails that extend above the edge. Move slowly. Reverse the steps to come down, and again face the ladder. Never lean out sideways to reach something. Come down, move the ladder, and climb again.
Wear eye protection if you will cut, scrape or hammer, and use hearing protection with loud power tools. Keep your center between the rails, with your belt buckle inside them.
Compare ladder types for roof work
Different ladder styles suit different roof jobs. The figures below come from the products on our comparison page, and a listed reach is a working height, not a rail length.
Check what each maker lists before relying on a ladder, because some leave out duty ratings or standards.
| Type | Example from our page | Listed reach | Capacity | Useful detail |
|---|---|---|---|---|
| Telescoping | SINMEIRUN 20.3 FT | 20.3 ft | 330 lb | Folds to 42 in, EN131 listed |
| Telescoping | SocTone RV Ladder | 12.5 ft | 330 lb | Includes a stabilizer bar |
| Multi-position | LANBITOU 14ft | 14 ft | 330 lb | Stabilizer bar, EN131 and ANSI listed |
| Multi-position | Little Giant Velocity | 18 ft | 300 lb | Type IA rating, transport wheels |
| Step ladder | KINGRACK 5 Step | Not listed | 800 lb | Free-standing, not for roof access |
Know when not to go up
Some conditions are a clear sign to wait. Rain, frost, wet leaves and strong wind all reduce your grip and your balance. A roof that is wet, mossy or covered in frost is slick, so postpone the job.
A steep roof, a roof with brittle or damaged sections, or a job that needs a lot of time at the edge may call for a professional with roof anchors and fall protection. A ladder gets you to the roof, but it does not protect you once you are on it.
Do not work alone if you can avoid it. Tell someone when you are going up, and keep a phone within reach. If you feel dizzy, tired or unsure of your footing, come down and rest.
If you are still choosing a ladder for this kind of work, our ladder comparison shows reach, weight and folded length so you can match a model to your roof height and to how you will store it.
Frequently asked questions
How far should a ladder extend above the roof?
About 3 feet above the roof edge. That gives you rails to hold while you step on and off.
Is it safe to climb a ladder by myself?
It is safer with a spotter who can foot the base and call for help. If you must work alone, tie off the ladder, tell someone your plan and keep a phone on you.
Can I use a metal ladder near power lines?
No. Metal conducts electricity, and even a ladder that only gets close can be dangerous. Keep well clear of lines, and call a professional or your utility if they run near the work area.
Should I use a stabilizer on a roof ladder?
It helps. A stabilizer bar widens the contact at the top and reduces wobble against the eave. It does not replace tying off the ladder.
How often should I inspect my ladder?
Before every use. Also inspect it after any fall, hard knock or long storage outdoors.
SINMEIRUN 20LOBest overall
KINGRACK WK2223-5DHighest load capacity
Soctone ZL0113Light RV and attic access