How to Clean Work Gloves Without Ruining Them
Yes, many work gloves can go in the washing machine, but only if the maker says so. Use cool water, mild detergent and air drying for most pairs. Leather and heavily padded gloves do better with gentle hand cleaning, because soaking and heat can stiffen and shrink them.
Check the label before anything else
The safest first step is to read the care tag or the product listing. Makers choose materials and glues for a reason, and the same glove can survive one wash method and fall apart in another. If you cannot find any care instructions, treat the gloves as hand-wash only.
Our spec sheets include a machine washable field where the maker provides one. On our best work gloves page, the JUMPHIGH synthetic leather pair, the MaxiFlex nitrile foam pair, the Schwer A5 cut-resistant pair and the Mechanix Wear Original are all listed as machine washable. The HANDLANDY 5972 and the DULFINE DF148 do not list washability, so you should not assume it. Wash those by hand with gentle care.
A quick way to sort your gloves:
- Coated knit gloves (nitrile or polyurethane on nylon): usually fine to wash if the maker allows it.
- Synthetic leather palms with foam padding: wash gently and air dry.
- Real leather gloves: hand clean only, and keep water to a minimum.
- Cut-resistant gloves: follow the maker's temperature limits closely.
How to wash work gloves in the washing machine
If the label allows machine washing, a few habits protect the gloves and your washer. Gloves hold grease, dirt and grit, so wash them apart from your clothes. Many care guides suggest washing gloves alone or with similar colors.
Here is a simple routine:
- Knock off loose dirt outdoors and shake out any debris from the cuffs.
- Close hook and loop straps so they do not snag the fabric or catch other items.
- Turn the gloves inside out if the back is a knit or spandex panel.
- Use a mild detergent and a cool water setting on a gentle cycle.
- Skip bleach, fabric softener and solvents. Bleach and solvents can break down coatings and stitching, and softener can leave a film that lowers grip.
- Run an extra rinse if the gloves were very dirty, so no soap is left in the palm.
How to hand wash gloves that are not machine safe
Hand washing takes about ten minutes and is gentler on padding and coatings. Fill a basin with cool or lukewarm water and add a small amount of mild soap. Put the gloves on and wash your hands, or work the suds into the palms and fingers with a soft brush.
Pay extra attention to the fingertips and palm, where grime collects. Rinse until the water runs clear. Then press out water with a towel instead of twisting, since wringing can tear stitching and distort foam padding.
Grease is the usual problem. A small dab of dish soap rubbed into oily spots before washing helps lift it. Always test any cleaner on a small hidden area first.
How to clean leather work gloves
Real leather reacts badly to soaking. Water can pull oils out of the hide, and when it dries the leather can turn hard and stiff. Spot cleaning is the better choice.
Dampen a soft cloth or sponge with water and a drop of mild soap. Test a small hidden patch first. If the color holds, wipe the glove in light circles, then go over it again with a clean damp cloth to remove soap. Let the gloves dry naturally, away from heat.
Once they are dry, work in a small amount of leather conditioner to bring back some softness. Synthetic leather palms are different. They are easier to wipe clean, and our listing for the JUMPHIGH pair describes its synthetic leather palm as shrink resistant. It still recommends cool water and air drying to keep the original size.
Dry them the right way
Heat is the biggest cause of ruined gloves. It can shrink fabric, harden leather and weaken coatings. In most cases, air drying is the best choice. Lay the gloves flat or hang them by the cuffs in a spot with good airflow, out of direct sun and away from heaters.
Some makers do allow a dryer. Schwer says its A5 cut-resistant gloves can be washed by hand or machine in warm water up to 160°F (71°C), and tumble dried for 10 to 15 minutes at no more than 150°F (67°C). That is a maker-specific rule, so do not copy it for other pairs. Check your own gloves first.
Make sure gloves are fully dry before you store them, or they can develop a musty smell. Keep them somewhere dry and not crushed under tools.
Quick comparison by glove type
Use this table as a starting point, then follow your own label.
| Glove type | Wash method | Drying | Watch out for |
|---|---|---|---|
| Coated knit (nitrile, polyurethane) | Machine wash if listed, or hand wash | Air dry | Fabric softener and hot water |
| Synthetic leather with padding | Gentle machine wash if listed, cool water | Air dry | Heat, which can change the fit |
| Real leather | Spot clean with a damp cloth | Air dry, then condition | Soaking and direct heat |
| Cut-resistant (for example Schwer A5) | Follow maker's limits | Maker allows short low-heat tumble | Water hotter than the stated limit |
Safety and when to replace gloves
Do not put gloves soaked in gasoline, solvents or other flammable liquids into a washer or dryer. Fumes can build up, and a dryer adds heat and a fire risk. Let them air out outdoors first, and dispose of them by your local rules if they are heavily contaminated. Wear eye protection and protective gloves when handling harsh chemicals.
After washing, check your gloves. Look for thin spots, loose stitching, peeling coating and worn fingertips. Cleaning cannot restore lost protection. A cut-resistant glove with a worn palm or a padded glove with flattened foam is no longer doing its job. If you are shopping for a replacement, our work gloves comparison lists washability next to grip, padding and cut rating.
Frequently asked questions
Can I wash gloves with my regular laundry?
It is better not to. Work gloves carry grease, grit and metal dust that can transfer to clothes and clog filters. Wash them on their own.
How often should I clean my work gloves?
Clean them when they look dirty, feel slick, smell, or lose grip. Grease and sweat can break down materials over time, so regular light cleaning helps.
Why did my gloves shrink or turn stiff?
Hot water and high dryer heat are the usual causes. Leather can also harden if it dries after a soaking without conditioning.
Can I use bleach to remove stains?
Avoid it. Bleach can weaken coatings, fade materials and damage stitching. Mild soap and a soft brush are safer.
How do I get the smell out?
Wash them according to the label, rinse well and dry them fully in open air. Storing damp gloves is what usually causes the smell to come back.
JUMPHIGH Best overall
HANDLANDY 5972Padded light-duty option
DULFINE DF148-12P-Red-LThin coated multipack