
VEVOR ZX0901-7BVEVOR Hydraulic Motorcycle Lift Jack ZX0901-7B
1500 lb hydraulic scissor jack with a foot pump.
- Lift capacity
- 1500 lb
- Maximum lift height
- 15.0 in
- Lift type
- Hydraulic scissor jack
A motorcycle lift raises your bike off the ground so you can clean it, change oil, adjust the chain or swap a wheel without kneeling on a cold floor. Scissor jacks slide under the frame and lift the bike a short way, which suits most home maintenance and fits under a bench when stored. Lift tables raise the whole bike to working height, which is much easier on your back but needs more floor space. Match the capacity to your bike, check the lowest height clears your frame, and always use the safety locks and tie-down straps. We put 16 motorcycle lifts on one spec sheet so you can compare them side by side.
Quick answer
Ranked from 16 motorcycle lifts that met our standard, compared on lift capacity, lift height range, platform length and width.
As an Amazon Associate I earn from qualifying purchases. Links to retailers on this site are affiliate links; we may earn a commission at no extra cost to you.

1500 lb hydraulic scissor jack with a foot pump.

Black Widow pneumatic table up to 31.25 in.

VIVOHOME at 4.5 in for low clearance bikes.
| Spec | ||||||||||
|---|---|---|---|---|---|---|---|---|---|---|
| Best Scoreout of 100 | 74 | 73 | 69 | 62 | 60 | 58 | 55 | 52 | 51 | 50 |
| Lift capacitylb | 1500 lb (best in row) | 1500 lb (best in row) | 1500 lb (best in row) | 1000 lb | 1100 lb | 1500 lb (best in row) | 1100 lb | 1500 lb (best in row) | 1500 lb (best in row) | 1100 lb |
| Lift type | Hydraulic scissor jack | Pneumatic/hydraulic table (best in row) | — | Pneumatic/hydraulic table (best in row) | Manual crank scissor jack | Pneumatic/hydraulic table (best in row) | Manual crank scissor jack | — | Pneumatic/hydraulic table (best in row) | Manual crank scissor jack |
| Minimum heightin | 4.7 in | 7.0 in | 4.5 in | 8.6 in | 3.7 in | 7.5 in | 3.5 in (best in row) | 3.5 in (best in row) | 7.5 in | 5.1 in |
| Maximum lift heightin | 15.0 in | 31.3 in | 14.8 in | 31.0 in | 13.8 in | 33.5 in (best in row) | 14.5 in | 16.8 in | 33.5 in (best in row) | 15.8 in |
| Platform lengthin | — | 105.5 in (best in row) | — | — | 14.4 in | 78.7 in | 14.6 in | 17.0 in | — | 14.6 in |
| Platform widthin | — | 48.0 in (best in row) | — | — | 9.0 in | 28.0 in | 9.0 in | — | — | 9.1 in |
| Product weightlb | 58 lb | 568 lb | 59 lb | — | 26 lb (best in row) | 463 lb | 28 lb | 90 lb | 556 lb | 31 lb |
| Power source | Hydraulic foot pump (best in row) | Air compressor (pneumatic) | Hydraulic foot pump (best in row) | Hydraulic foot pump (best in row) | Manual crank | Hydraulic foot pump (best in row) | Manual crank | Hydraulic foot pump (best in row) | Hydraulic foot pump (best in row) | Manual crank |
| Casters for moving | Yes | Yes | Yes | Yes | — | — | — | Yes | — | Yes |
| Adjustable wheel chock/clamp | — | Yes | — | Yes | — | — | — | — | — | — |
| Safety lock/pin | Yes | Yes | Yes | Yes | Yes | — | — | Yes | — | — |
| Side extension/loading ramp included | — | Yes | — | — | — | Yes | — | — | Yes | — |
| Tie-down straps included | Yes | — | Yes | — | — | — | — | Yes | — | — |
We reviewed 38 motorcycle lifts and kept only the 16 that pass every check below. Those are ranked by a Best Score built from spec fit for this job, sales rank.
These reviews are based on each lift's published specifications and listing information, in the order of our ranking.
VEVOR ZX0901-7B hydraulic jack for most motorcycles
The VEVOR ZX0901-7B leads our ranking. It is a hydraulic scissor jack with a 1500 lb capacity, tied for the highest on this page, enough for heavy cruisers and touring bikes as well as sport bikes, dirt bikes and small ATVs. A foot pump with a long handle raises the bike with little effort, so you keep both hands free to steady it.
It lowers to 4.7 in to slide under most frames and raises to 15 in, which is enough to lift a wheel off the ground for chain, wheel and suspension work. A 3-position safety pin locks it at the height you choose, and a non-slip rubber striped platform plus two ratchet tie-down straps keep the bike from leaning or sliding.
Two universal and two directional casters let you roll it into position under the bike and move it around the garage. At 58 lb it is heavier than a manual jack but still portable. It will not raise a bike to standing height like a lift table. For most home riders, it is the best mix of capacity, ease and safety here.
VerdictThe best motorcycle lift on this page for most riders.
Black Widow ProLift, a full-size pneumatic lift table
Second in our ranking, the Black Widow ProLift is a full-size motorcycle lift table. A foot pedal raises bikes up to 1500 lb from 7 in to 31.25 in off the ground, so you can work sitting or standing instead of crouching. It needs 90 to 110 PSI from an air compressor.
You push the bike onto the platform and into the adjustable wheel clamp, which keeps it upright while you tighten the wheel vise and attach safety straps. Its platform is 105.5 in long and 48 in wide, the largest on this page, with side extensions, so it fits big touring bikes and gives you room to kneel or put tools beside the bike.
It is heavy-duty powder-coated steel and comes with a removable 20 in ramp, integrated dolly wheels, a rear drop-out panel for wheel removal and a center jack. At 568 lb it is the heaviest lift here and takes a lot of floor space. For serious riders and home shops with room and a compressor, it is the best work platform here.
VerdictThe best full-size lift table here.
VIVOHOME VH049 hydraulic jack with low clearance
The VIVOHOME VH049 ranks third. It is a foot-pedal hydraulic jack with a 1500 lb lifting capacity, tied for the most here, and VIVOHOME says it fits most motorcycles, dirt bikes and ATVs. It lowers to 4.5 in, slightly lower than the VEVOR leader, which helps with bikes that sit close to the ground.
It adjusts from 4.5 to 14.8 in. A 3-position mechanical safety lock holds the bike at the height you need, and VIVOHOME says to always use the two included tie-down straps to stop any sideways lean, which is good advice for any jack-style lift.
It is built from alloy steel with a powder-coated finish that resists oil, grease and rust, and a non-slip rubber pad protects the frame from scratches. It weighs 59.4 lb. VIVOHOME notes it is not suitable for some models, so check the frame shape under your bike. For riders who want a capable hydraulic jack with a low profile, it is a close alternative to the VEVOR.
VerdictA strong low-profile hydraulic jack.
VEVOR 1000 lb hydraulic lift table
Fourth in our ranking, the VEVOR JL-M03108 is a hydraulic lift table that raises bikes from 8.6 to 31 in, so it gives the same standing-height working position as larger tables without needing an air compressor. A foot pedal pump does the lifting.
Its 1000 lb capacity covers most standard motorcycles, many touring bikes and dirt bikes, though very heavy baggers may exceed it. A wheel clamp holds the front wheel and a safety lock secures the platform at height.
Two 360° swivel casters and two directional casters, with two locking brakes, let you move it around the garage and park it out of the way. It lowers to 8.6 in for compact storage. For riders who want a work-height table without a compressor or the size of a full shop lift, it is a good value choice. Always lock the platform and strap the bike before you start work, and lower it slowly with the release.
VerdictThe best budget lift table here.
VEVOR M110201 manual scissor jack
The VEVOR M110201 completes our top five. It is a manual crank scissor jack with an 1100 lb capacity, enough for most motorcycles. You raise it with a spin of the detachable metal handle, with no tools or hydraulics to maintain.
It lowers to 3.7 in, the lowest in our top five, and raises to 13.8 in. Its steel X-frame central shaft holds the bike at various positions, and a 6-position safety pin locks it securely. A 14.4 × 9 in wide top platform reduces shaking and sliding during lifting.
At 26 lb it is the lightest jack in our top five, so it is easy to carry to a track day or store on a shelf. Cranking is slower than a foot pump. For riders who want a simple, light jack for basic maintenance, it is a practical choice. Use tie-down straps to steady the bike, and check that the frame sits squarely on the platform before lifting.
VerdictThe best light scissor jack here.
Best among the reviewed tools
Scissor jacks lift the bike a short way for maintenance. Lift tables raise it to working height but need more floor space.
Check your bike's weight, including fluids. Lifts here range from 300 to 1500 lb.
Minimum height must clear your frame. Maximum heights here range from 13.8 to 34.25 in.
Use safety locks and tie-down straps every time. Wheel clamps on lift tables keep the bike upright.
Many can. Check the lift capacity against your bike's weight and that the minimum height fits under its frame.
If you work on your bike often, yes. Working at standing height is far easier on your back.
Yes. Straps stop the bike leaning or sliding off the jack while it is raised.
Yes. Pneumatic tables need an air supply. Hydraulic foot pump lifts do not.
Your own selection is kept in the link, so friends see the same side-by-side.